Adjustments; Replacing Parts - Ndustrio 091CP1E Manuel D'utilisation Et D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

4 - Connect the circuit-breaker (A) to the terminal
board (E) of the appliance as shown in the dia-
gram and in the electrical system diagram at
the back of the manual. Use a flexible cable
with at least type H07RN-F characteristics, rat-
ed for an operating temperature of at least
80°C.
TESTING OF THE APPLIANCE
Important
Before it is put into service, the system
must be tested to check the operating con-
ditions of every single component and
identify any malfunctions. In this stage, it is
important to check that all health and safety
requirements have been complied with in
full.
To test the system, make the following checks.
1 - Turn on the water supply tap and make sure
that the connection is watertight.
ADJUSTMENTS PROCEDURE
The appliance's main functions do not require any
special adjustments by specialist staff except the
REPLACE PROCEDURE
The appliance does not require the replacement of
operating components by specialist staff except the
DECOMMISSIONING THE APPLIANCE
Important
This operation must be carried out by skilled
operatives in compliance with the legal re-
quirements with regard to safety at work.
Never dump non-biodegradable materials, lu-

ADJUSTMENTS

REPLACING PARTS

- 17 -
Important
When connecting, take care to connect the
neutral and earth lines.
5 - Replace the guard (D).
6 - Close the door (A) when the operation is com-
plete.
2 - Check that the mains voltage is the same as
that of the appliance.
3 - Operate the appliance's circuit-breaker to
check the electrical connection.
4 - Check that the safety device is operating cor-
rectly.
After testing, if necessary instruct the user in all the
skills necessary for putting the appliance into oper-
ation in conditions of safety, in accordance
with legal requirements.
settings made during use by the user.
replacement of standard parts which can be carried
out by the user.
bricating oils and non-metallic components
(rubber, PVC, resins, etc.) in the environ-
ment. Dispose of them in accordance with
the relevant legal requirements.
8
IT
GB
9
DE
FR
ES
English

Publicité

Table des Matières
loading

Table des Matières