Description Of The Hood & Controls; Controls - Elica Mezzano Série Guide D'utilisation, D'entretien Et D'installation

Description of the hood & Control
7
6
1
4
1. Blower and light controls
2. Lamp housings
3. Grease filter Handle
4. Grease Filter
5. Canopy
6. Duct covers
7. Louver holes (Only for Recirculating version)

Controls

This hood is equipped with an electronic motor and lamp
control. The control is able to set 3 diferent fan speeds, turn
ON/OFF light and has a timer function. In the folloring draw-
ing are described the main key fuctions.
Description of control panel
1. Timer Button
• The default timer setting is 10 minutes, and it can
adjusted between 20 minutes and 1 minute.
• After pressing the timer key, the control enters
to a timer setup mode, and user can adjust the
timer countdown time with the "-" and "+" keys
within 5 seconds. The timer can be initiated im-
mediately pressing the timer key, after setting
the timer duration or pressing the timer key twice
(default 10 minutes setting).
5
3
2
BUTTON
BUTTON
• If not action occurs within 5 seconds the count-
down will start.
• During the timer setup the "-" and "+" keys are
dedicated to the timer and no motor action will
occur.
• Once initiated the timer, it can be cancelled by
pressing the timer key again.
2. Light Button
• Press lamp key to turn ON the light (Lamp state
previously OFF).
• Press lamp key to turn OFF the light (Lamp state
previously ON).
3. Display
• Shows the hood settings.
4. "-" Button. Speed Decrease / OFF
• This button is used to decrease tha fan speed, or
turn OFF the fan.
• The fan will turn OFF if the "-" button is pressed
and the hood was in the first speed.
• If the fan is at second speed and the "-" button is
pressed, the fan will be set to first speed.
• If the fan is at third speed and the "-" button is
pressed, the fan will be set to second speed.
• If the fan is OFF and the "-" button is pressed, the
control backlight will light up.
5. "+" Button. Speed Increase /ON
• This button is used to increase the fan speed, or
turn ON the fan.
• The fan will turn On if the "+"button is press and
the hood was OFF.
• If the fan is at first speed and the "+" button is
pressed, the fan will be set to second speed.
• If the fan is at second speed and the "+" button is
pressed, the fan will be set to third speed.
• If the fan is at third speed and the "+" button is
pressed, a beep will sound.
Clock programming
• The clock can be reprogrammed at any time except dur-
ing an active timed fuction.
• The clock can be displayed in a twelve hour format and
valid clock times are from 1:00 to 12:59.
• The clock can be reprogrammed pressing the "Timer" but-
ton for 5 seconds, and after, the clock can be adjusted
with the "+" and "-" buttons. Colon ":" will flash indicating
clock programing mode.
• The user can have minute increments / decrements of 1
minute, but if the user keep pressing the "+" / "-" buttons
for more than 1 second, the increments / decrements will
be of 5 minutes. During this option the control will round to
the nearest 5 minutes.
• The user can finish on reprogramming the clock pressing
the "Timer" button.
11