Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Commissioning
•
Unwind the mains cable completely.
•
Attach a nozzle if necessary.
•
You can dry single hair locks by concentrating the flow
of hot air with the hairdressing nozzle.
•
The diffuser is the ideal solution to dry curly hair without
losing volume.
•
In order to replace the attachment, first remove the old at-
tachment by pulling it off and then pushing on the new one
until it clicks into place.
Electrical Connection
•
Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
•
Connect the appliance to a properly installed earthed
socket.
Use
Setting the Temperature Level (right switch):
Position • :
cold air
Position •• : medium temperature for gentle drying and
shaping
Position ••• : high temperature for rapid drying
WARNING:
• Before cleaning remove the mains lead from the socket.
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
CAUTION:
•
Do not use a wire brush or any abrasive items.
•
Do not use any acidic or abrasive detergents.
Clean the housing with a soft, dry cloth without additives.
32
Setting the desired blower strength (left switch):
Position 0:
Position
Position
Button
Switch-off
After use, slide the switch to position "0" and disconnect from
the mains.
Storage
•
•
Mains Cable
•
•
•
Maintenance and care
Air Intake Grill
Please clean the grill on the air intake side of the hairdryer
regularly in order to avoid excessive temperatures as a result of
heat accumulation.
•
•
•
•
•
cold air
: gentle stream of air
: strong stream of air
: With this switch it is possible to interrupt
the heating process so that the air can be
mixed according to individual requirements.
Hold the button down in this position ac-
cording to the desired interval length. When
the button is released it returned automati-
cally to the initial position.
Leave the device to cool before putting it away! To do so,
place the appliance onto one side of the housing or hang it
up by the suspension eye.
Fold the handle up to save space and keep the appliance
in the see-through bag.
The mains cable should only be wound up loosely.
Never tie the cable tightly round the device, as over time
this may result in the cable breaking.
Check the mains cable regularly for damage.
Remove any dirt that is present.
If necessary, a fine brush can be used.
Twist off the grille in an anticlockwise direction, remove the
air inlet filter and clean it under running water.
Please allow the filter to try before reinserting it.
Turn the grille tight in a clockwise direction.
Publicité
Table des Matières
