Cleaning And Care - BOMANN HT 8002 CB Mode D'emploi

1. Fully unwind the mains cable.
2. Make sure that the iron voltage (see name plate) and the mains voltage match.
3. Attach a nozzle if necessary. You can dry single hair locks by concentrating the flow of
hot air with the hairdressing nozzle.
4. Insert the plug into a duly installed protective contact socket.
5. Shift the switch on the handle to one of the desired heat/blowing levels:
Level 0:
Level 1:
Level 2:
Switch-off
After use shift the switch to position "0" and pull out the plug. Leave the device to cool before
putting it away! To this purpose place the device on one side of the housing or hang it up by
the suspension lug.
WARNING:
• Before cleaning remove the mains lead from the socket.
• Do not immerse the appliance in water under any circumstances. This could result in
an electric shock or fire.
• Clean the housing with a soft, dry cloth without additives.
Mains Cable
• The mains cable should only be wound up loosely.
• Never tie the cable tightly round the device, as over time this may result in the cable
breaking.
• Check the mains cable regularly for damage.
Air Intake Grill
• Please clean the grill on the air intake side of the hairdryer regularly in order to avoid
excessive temperatures as a result of heat accumulation.
• Remove any dirt that is present. If necessary, a fine brush can be used.
Commissioning
off
medium airflow and medium temperature
strong airflow and high temperature

Cleaning and care

GB
41