Overview Of Functions; Cleaning And Care; Noise Development; Technical Data - BOMANN HTD 804 CB Mode D'emploi

Overview of Functions

Display
1 Hot air
2 Ionisation
3 Cold air
4 Fan
5 Blower level
6 Temperature
7 Heating level
Control Lamp
8 Cold air
9 Ionisation
10 Fan
11 Hot air
Buttons
12 Cold level
13 Ionisation
14 Fan / ventilator
15 Heating level
Basic Functions
• Press button 12 to switch between cold and hot air.
• With button 13 you can switch ionisation on and off.
• With button 14 you can increase the blower level.
• By pressing button 15 you can select a heating level in
conjunction with the blower level that has been set.
Cold Function (COOL SHOT)
• When the dryer is set to cold you can increase the blower
levels and switch ionisation on and off.
• The lowest blower level follows after the highest one.
Heating Function
• The heating level can be selected according to the blower
level.
Examples:
• At the lowest blower level only the lowest heating level
can be switched on in order not to overheat the device.
• If you would like to reduce the blower on a high heating
level, it is fi rst necessary to reduce the heating level.
• The ionisation function can be switched on and off at any
time.
Ionisation function – Reducing electrically charged hair
The device is also fi tted with an ioniser which gives off negative
ions together with the air that is emitted. This process helps to
protect the hair when it is being dried while simultaneously help-
ing to improve hair structure, increase the volume of the hair,
produce a silky sheen and also reduce the static charge of the
hair. This process is particularly gentle for stressed hair.
26
05-HTD 804 CB.indd 26 05-HTD 804 CB.indd 26
Switch-off
• Turn the device off with the toggle switch and remove the
mains plug from the socket.
• Leave the device to cool before putting it away!
• Hang the device up by the suspension eye.
Mains Cable
• The mains cable should only be wound up loosely.
• Never tie the cable tightly round the device, as over time this
may result in the cable breaking.
• Check the mains cable regularly for damage.

Cleaning and care

WARNING:
• Before cleaning remove the mains lead from the socket.
• Under no circumstances should you immerse the device
in water for cleaning purposes. Otherwise this might result
in an electric shock or fi re.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Clean the housing with a soft, dry cloth without additives.
Air Intake Grill
Please clean the grill on the air intake side of the hairdryer
regularly in order to avoid excessive temperatures as a result of
heat accumulation.
• Press on the mark above the air suction grille with your
thumb in order to fold it open.
• Remove any dirt that is present.
• If necessary, a fi ne brush can be used.
• Close the grille by locking it into place.

Noise development

The sound pressure level in the ear of an operator (LpA) was
measured according to DIN EN ISO 3744.
Sound pressure level detected: 82 dB(A) (no limit)

Technical Data

Model: ........................................................................HTD 804 CB
Power supply: ............................................................230 V, 50 Hz
Power consumption:
P : ............................................................................2000 W
nom.
P : ............................................................................2200 W
max.
Protection class: .......................................................................... ΙΙ
Net weight: ........................................................................0,60 kg
18.12.2008 15:36:00 Uhr 18.12.2008 15:36:00 Uhr