FUST NOVAMATIC SÖ1840-IB Notice D'utilisation page 52

Problem
Power indicator light is flash-
ing.
The lid doesn't close com-
pletely.
The lid is difficult to open.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after press-
ing the ActionFreeze, or after
changing the temperature.
Possible cause
An error has occurred in
measuring the temperature
or the appliance is not work-
ing properly.
Food packages are blocking
the lid.
There is excessive frost.
The lid gaskets are dirty or
sticky.
The valve is blocked.
The lamp is defective.
Temperature is set incorrect-
ly.
Large quantities of food to be
frozen were put in at the
same time.
The room temperature is too
high.
Food placed in the appliance
was too warm.
The lid is not closed properly.
The ActionFreeze function is
switched on.
The lid is not closed correctly
or the gasket is deformed/
dirty.
The water drainage plug is
not correctly positioned.
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
Solution
Contact the nearest Author-
ized Service Centre.
Arrange the packages in the
right way, see the sticker in
the appliance.
Eliminate excess frost.
Clean the lid gaskets.
Check the valve.
Refer to "Replacing the
lamp".
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food to cool to room
temperature before storing.
Check if the lid closes well
and the gaskets are undam-
aged and clean.
Refer to "ActionFreeze func-
tion".
Refer to "Opening and clos-
ing the lid".
Position the water drainage
plug in the correct way.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
52