Periods Of Non-Operation; Troubleshooting - FUST NOVAMATIC SÖ1840-IB Notice D'utilisation

51
The amount of frost on the walls of the
appliance will be increased by the high level
of the outer environment humidity and if the
frozen food is not wrapped properly.
The best time to defrost the freezer when it
contains no or only a little food.
1. Switch off the appliance.
2. Remove any stored food, wrap it in
several layers of newspaper and put it in
a cool place.
3. Leave the lid open , remove the plug
from the defrost water drain and collect
all defrost water on a tray.
4. When defrosting is completed, dry the
interior thoroughly and refit the plug.
5. Switch on the appliance.
6. Set the temperature regulator to obtain
the maximum coldness and run the
appliance for two or three hours using
this setting.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
Problem
The appliance does not oper-
ate.
The appliance is noisy.
Audible or visual alarm is on.
7. Reload the previously removed food
into the compartment.

Periods of non-operation

When the appliance is not in use for long
periods, take the following precautions:
1. Switch off the appliance and disconnect
the appliance from electricity supply.
2. Remove all food
3. Defrost and clean the appliance and all
accessories.
4. Leave the lid open to prevent
unpleasant smells.
Possible cause
The appliance is switched off.
The mains plug is not con-
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not suppor-
ted properly.
The cabinet has been recent-
ly switched on or the temper-
ature in the appliance is too
high.
If the cabinet will be kept on,
ask somebody to check it once
in a while to prevent the food
inside from spoiling in case of a
power failure.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect to a different electri-
cal mains socket. Contact a
qualified electrician.
Check if the appliance stands
stable.
Refer to "High Temperature
Alarm" and if the problem still
occurs contact the nearest
Authorized Service Centre.