Steelcase Migration SE Manuel D'utilisation page 15

Masquer les pouces Voir aussi pour Migration SE:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 46
_______________________________________________________________
Limiting height adjustability
These settings could limit the desktop
movement range (should there be a rolling
file cabinet under the desk or a set of
shelves above it).
The stopping positions for the rolling file
cabinet become the new bottommost end
position, and the shelf stopping positions
become the new topmost end position.
Move the desktop to the lower halve or the
upper halve of the movement range.
Press and hold the "SAFE" button for 10
seconds
The position is being saved.
=
Changing the displayed unit – C M/INCH
Simultaneously press and hold the buttons
"1", "2" and "Up" for three seconds; then
release the buttons.
The letter S and a number (e.g. S 7) are
=
indicated on the display.
Press and hold the "Up" button until S 5 is
indicated on the display.
S 5 is displayed.
=
Press the "SAFE" button.
If the display was previously set to
=
centimetres (cm), it will now be switched
over to inches (inch) and vice versa.
153310
Operating and adjusting
Resetting to factory settings
This function can be used to reset the DM
system to its factory settings.
Press the following buttons for 3 seconds
(then release them):
When S O is indicated on the display:
Press the (SAVE) button very briefly:
Lines move back and forth on the
display.
Wait 3 seconds, 0 should be indicated on
the display: Then press the button shown
below:
The desktop moves downward until it
has reached the lower end position.
When the table has reached the lower end
position, and 64.9 is indicated in the
display: Press the button shown below:
The desktop moves upward.
The reset to factory settings is concluded.
=
15

Publicité

Table des Matières
loading

Table des Matières