Steelcase Migration SE Manuel D'utilisation page 17

Masquer les pouces Voir aussi pour Migration SE:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 46
_______________________________________________________________
Table of error messages with the Memory control panel
Signal/Code
Message
The overheating protection circuit has
HOT
been activated.
ISP
The system has detected a collision.
CON followed by
The system has detected a connection
ERR
error.
ERR followed by
An internal error has occurred.
ERROR NUMBER
Signal/Code
1
2
153310
Required measure(s)
Wait until the overheated components have cooled down.
Release all buttons and wait until the drive back function
process is completed.
Release all buttons and wait 5 seconds. Then try again.
Disconnect the power supply from the power supply line.
Then disconnect the system from the power supply. Re-
connect the DM system and use it as usual.
Read the table below to determine the correct corrective
measure for the indicated error code.
Message
Firmware error
Overcurrent with motor
Errors and malfunctions
Required measure(s)
Disconnect the power supply from the
power supply line.
Then disconnect the system from the
power supply.
Re-connect the DM system and use it
as usual.
Release all buttons and wait 5 seconds.
Then try again.
17

Publicité

Table des Matières
loading

Table des Matières