Hitachi WH 14DAF2 Instructions De Sécurité Et Mode D'emploi page 13

2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown
in Fig. 4. Make sure it contacts the bottom of the
battery charger.
3. Charging
When the battery is connected to the battery charger, charging will commence and the
pilot lamp will light on.
NOTE: If the pilot lamp dose not light, pull out the plug from the receptacle and check
if the battery is properly mounted.
In approx. 30 min., when the battery is fully charged, the pilot lamp will go out.
NOTE: The battery charging time becomes longer when a temperature is low or the
voltage of the power source is too low.
When the pilot lamp does not go off even if more than four hour has passed
after start of the charging, stop the charging and contact your HITACHI
AUTHORIZED SERVICE CENTER.
4. Disconnect battery charger from the receptacle.
CAUTION:
Do not pull the plug out of the receptacle by pulling on the cord.
Make sure to grasp the plug when removing from receptacle to avoid damaging cord.
5. Remove the battery from the battery charger.
Supporting the battery charger with hand, pull out the battery from the battery charger.
CAUTION:
When the battery charger has been continuosly used, the battery charger will be heated,
thus constituting the cause of the failures. Once the charging has been completed,
wait 15 minutes rest until the next charging.
If the battery is recharged when it is warm due to battery use or exposure to sunlight,
the pilot lamp may not light.
The battery will not be recharged. In such a case, let the battery cool before charging.
Regarding electric discharge in case of new batteries, etc.
As the internal chemical substance of new batteries and batteries that have not been
Battery
Fig. 4
English
Pilot lamp
13