Assembly And Use Of The Hoop Lock; Inspection, Care And Maintenance; General; User Instructions - Altrex Everest Manuel De Montage Et D'utilisation

EN
III

Assembly and use of the hoop lock

III.I

Inspection, Care and Maintenance

1 The hoop lock must be handled and transported with care, in order to avoid damage.
2 Check all moving parts for correct functioning and to ensure that these are not contaminated.
3 Check all parts for damage. Damaged or incorrect parts may not be used.
4 Damaged parts have to be returned to the manufacturer for inspection.
5 The hoop lock must be inspected annually by an expert. The services of the Inspection, Repair and
Assembly department at Altrex can be engaged for inspections and any repairs.
III.II General
Only use the hoop lock in the configuration shown below.
!
Before using the hoop lock, also read the standard instructions for use belonging to the hoop lock (see
!
chapter I).
Parts supplied for the hoop lock:
!
Nr. Description
1 Hoop lock
2 Intermediate plate
3 Angle section
4 Padlock
5 Pop rivets
*
part of 735580, obtained by sawing off the end of the bracket
**
part of the assembly hoop lock 202304
If fastenings are delivered, please check that these are suitable for the site where these have to be
!
fitted.
III.III User instructions
Opening:
Undo the padlock.
-
Remove the padlock from the angle section and U-shaped profile.
-
The hoop lock can be opened sideways by hand.
-
Closing:
Turn the hoop lock sideways by hand.
-
Make sure that the hole of the U-shaped profile (on the hoop lock) is located above the hole of the angle section (on the
-
ladder)
Pass the padlock through the holes.
-
Lock the padlock.
-
Art. no. Quantity
202304 1
735580 * 1
602007 ** 1
737032 ** 1
706026 6
22 / 32
"#!
!