Start Of Accessory; Accessories - Texas A/S Pro Trac 700 Mode D'emploi

10. Start of accessory

Disengage the clutch and connect the PTO. Increase the engine revolutions and release
the clutch handle slowly. When work is completed, disconnect PTO and the engine stops.

11. Accessories

Tiller.
The rear fitted tiller is used to prepare the ground for sowing. The tiller is equipped with a
debth skid, which guide the debth of the tiller. When the debth skid is up, the tiller is work-
ing at the maximal debth. When the debth skid is down, the tiller works with minimum
debth.
The working depth may be adjusted by lifting/lowering the knives. On the top of the filler
box, where the knives are fitted you may change the depth by moving the bolt that attach-
es the knives. The box has 6 different positions for fitting the knives.
Max. work depth is approx. 20 cm.
It the ground is hard it is advisable to use first gear. If the ground is sandy and soft, second
gear may be used.
Transportation wheel.
The tiller may be fitted with a wheel for transportation, which is ideal if the machine is to be
transported for longer distances.
RIdger.
There are two kinds of ridger. One is fitted directly to the end of the tiller and the other kind
is fitted directly onto the machine. In this case a special console is needed.
When you use the kind that is fitted onto the tiller, the work width must be reduced to 33
cm as only one rotor on each side is used.
Snow thrower.
o
For winter a snow thrower may be fitted. If you do so, the steer must be turned 180 . Turn
the steer as follows: Dismount the rotary tiller and then all the handles. Turn the steer to
the left. The trigger pin for the steer is placed on the right side of the steer on model 700
and on the left side of 900. Re-mount the handles and remove the lockbolt for the PTO.
The Lockbolt for the PTO is the little bolt with the big round disc placed on the lower
lever. Now the steer is turned and you may use front mounted accessories.
See chapter 9.
When you want to use the rotary tiller again, remember to mount the lockbolt again, it is
your safety.
The snow thrower is 70 cm wide and may be used on snow with a depth of max. 40 cm.
Remember to tighten the bolts that attach the snow thrower.
22