Ibiza sound DJM250BT Manuel D'utilisation page 4

Controls
1. Mic 1 Socket
Connect your microphone with 1/4" jack plug here.
2. MIC Level Control
With this knob, you can adjust the microphone volume。
3. MIC Treble
Used to increase or lower the microphone's higher frequencies.
4. MIC Bass
Used to increase or lower the microphone's lower frequencies.
5. Talkover Button
Press this button if you want to use your microphone. When the button is pressed, all other signal sources
will be attenuated by 14dB, so that the microphone can be clearly heard. In the OFF position, all signals
returns to their original level.
6. Phono/Line Switch
Use this switch to select the input to be sent to the individual channel.
7. Treble Control
Used to increase or lower the HIGHS of the input channel.
8. Middle Control
Used to increase or lower the MIDS of the input channel.
9. Bass Control
Used to increase or lower the LOWS of the input channel
10. Channel Fader
Used to adjust the level of each channel.
11. Crossfader
Mixes the signals of one channel with another. If the crossfader is in the center position. Both channels can
be heard.
12. Headphone Socket
Connect your headphone with impedance between 8 and 600 Ohms to this connector.
13. Cue Button
Use this button in order to select the channel(s) to be monitored by headphones.
14. HEADPHONE LEVEL CONTROL
Let you to control the volume level of headphone
15. HEADPHONE CUE/PGM CONTROL
Allows you to listen simultaneously or separately to the CUE material or the active program.
16. Master Control
Adjust the level of the master-output.
17. Master Level Display
The LED display shows the level of the left and right master output
18. BOOTH Control
This knob controls the overall output level leaving the booth unbalanced RCA outputs.
19. MP3 PLAYER & BLUETOOTH
To refer USB / SD / BLUETOOTH PLAYER OPERATION below
©Copyright LOTRONIC 2014 DJM150BT 4