LGB 28003 Instructions De Service page 9

5: Announcement, spoken in the "Platt-
deutsch" dialect: "Leewe Lüt, stiegt
man in. Set you doal un moak de
Döarn to. De Toch fahrt nu aff." (Dear
people, get on the train. Sit down and
close the doors. The train is going to
leave now.)
6: Brake sound
7: Coal shoveling
8: Air pump, slow
Hint: If this model is equipped with a
decoder, the digital/analog DIP switches
on the loco circuit board will be set to
OFF. The DIP switches should remain in
this setting, even if the models are used
on an analog layout.
Lighting
This model features directional lighting.
The model has a "flat" multi-purpose
socket, with a removable cover, on the
rear of the cab. This socket can be used
to provide track power to cars with
lighting or sound electronics.
To remove the cover of the socket, pull it
straight out. If the cover is tight, gently
use a small straight screwdriver to pry it
out. (Do not pull out the rectangular
outer housing.)
Sound
This model features a digital electronic
sound system. The volume control is
located under the removable rear steam
dome (Fig. 6).
Bell and whistle: The whistle sounds
automatically when the locomotive is
started.
The bell and whistle can also be trigge-
red by the LGB Sound Magnet (17050)
included with this model. The 17050
snaps between the ties of most LGB
track sections.
The magnet in the 17050 is under the
LGB logo. If the contact is installed with
the logo on one side of the track, it will
trigger the whistle as the model passes.
If the contact is reversed, it will trigger
the bell.
Air pump: After the model stops, the air
pump sounds several times, then you
hear the injector and the safety valve. If
a low voltage (approx. 6.5 volts) is main-
tained, the standing sounds will conti-
nue to sound at regular intervals while
the loco is stopped.
Hint: If this model is not used for a long
time, its capacitors will discharge, and
the sound system will operate erratical-
ly. To recharge the capacitors, operate
the model at brisk speed for about 30
seconds. This model does not require a
battery.
Hint: This model is equipped with a star-
ting delay circuit. This enables the model
to produce standing sounds while it is
stopped.
Attention! Do not connect this model to
other loco models with different starting
characteristics. This can damage the
internal gearing.
Smoke Generator
This model is equipped with a smoke
generator. A small supply of LGB Smoke
and Cleaning Fluid is included with this
model. For best operation, fill the gene-
rator halfway with fluid. If the generator
is overfilled, it will not convert the fluid
into smoke.
Attention! Only use LGB Smoke and
Cleaning Fluid (50010). Other fluids may
damage your locomotive.
Attention! Never touch the heating ele-
ment in the center of the smoke genera-
tor. It is fragile.
Power Supply
Attention! For safety and reliability, ope-
rate this model with LGB power supplies
(transformers, power packs and con-
trols) only. The use of non-LGB power
supplies will void your warranty.
Use this model with LGB power supplies
with an output of at least 1 amp. For
more information on LGB power sup-
plies for indoor, outdoor and multi-train
operation, see the LGB catalog.
Attention! After extended operation, this
model may leave carbon dust or other
debris around the track. This dust and
debris can stain carpet and other mate-
9