Guardian G3-100KBRX1 Mode D'emploi Et Garantie page 3

7. Turn transfer bench right-side
up. Attach armrest by depressing
pushbuttons and sliding into the
arm receptacle on the side of the
bench. Make sure the arm arcs
outward, not inward. (Figure 4)
8. To assemble backrest, insert
support tube into backrest support
by depressing pushbutton and
sliding into backrest tube. Repeat
for second support tube.(Figure 5)
9. Insert backrest into base by
depressing pushbuttons and
sliding support tubes through both
receptacles. Note: Backrest must go
through both sets of receptacles to
become secure. (Figure 6)
NOTE: Back support is reversible to
accommodate left or right tub entry.
You can also change the seat depth
of your transfer bench by pushing
the pins under the seat and sliding
the tubes forward until the pins lock
into place.
10. Place legs with the large suction cups into bath tub,
smaller feet outside the tub.
Adjusting Leg Height
1. Before using the bench, make sure all legs are set to
the same preferred height. When your desired height is
reached, lock legs into place by aligning pushbuttons
with holes until they "snap" into place.
2. Make sure legs are locked into place by pushing down
and pulling up on each leg.
CAUTIONS:
1. Inspect all parts for possible damage before assembling.
If there is any damage - DO NOT USE. Contact dealer/
carrier for further instructions.
2. Make sure that the height adjusting pushbuttons fully
extend through the same corresponding hole of each
Figure 4
Figure 5
Figure 6
1-800-MEDLINE (633-5463) | medline.com 3