Panasonic TY-VK55LV2 Manuel D'installation page 35

8. Aligning
If the gap between adjacent units is large or differs at the top and bottom or at the left
and right sides, align the unit.
■...Alignment procedure
① Turn down the rotary lever for the surface
alignment magnets Ⓖ (to lock the magnets).
② Adjust the adjustment range gauges ⓐ to ⓔ
of the unit that will serve as the base position
totheir center positions. (They are set at the
center position upon shipment.)
( [Operating the adjustment knobs] pages 36 to 37)
③ Based on the base position, adjust the
position using adjustment knobs (1) to (4), in
that order.
④ Pull out the main unit and turn the rotary
lever for the surface alignment magnets Ⓖ
back (to unlock the magnets).
Push in the main unit.
⑤ Check that the magnets of the surface
alignment magnets Ⓖ enter the holder of the
adjacent surface alignment magnets Ⓖ and that
the main unit's screen is lined up.
* For the order in which the units should be installed
when mounting multiple units, see page 33.
Note
• Pull out the main unit before locking the magnets.
(Check that the magnets do not enter the adjacent holder.)
Ⓖ Surface alignment magnets
Lock
Rotary lever
Unlock
Rotary lever
Ⓖ Surface alignment magnets
Holder
(no magnets)
Magnets
Magnets
35