Westfalia 316 123 300 107 Instructions De Montage page 19

Installation Instructions: Electrical System for Towing Hitch
Installing electrical kit
1. Disconnect the negative terminal from the battery.
2. Remove the panelling from the left and right tail light, disassemble tail light.
3. Remove plugs at outside left and right in the rear floor panel. Drill holes at left to 39mm Ø, at
right to 21 mm Ø.
4. Disconnect the 4-pin connection in the wire lane!
Lay socket wire lane and 4-pin wire line from inside through the left bore hole to the outside
and through the tail rack to the socket retaining plate.
5. Carry on laying the 4-pin plug connection through the tail rack to the right side, and back
through the new bore hole into the interior to the right tail light.
6. Re-connect the 4-pin plug connection
7. Insert the rubber bushings into the installed bore holes.
Assembly of the screw-affixed socket
8. Connect the wire lane in accordance with the socket wiring plan (fig. 2) on the socket (fig.
1/7) and place the rubber seal on the socket.
9. Affix the socket on the retaining plate (fig. 1/7) with the screws and nuts provided
Renault Kangoo 316 123 391 101-23/02
19