Operation; Before Initial Use; Energy Saving Tips; Using The Cooler - Dometic CSMP2 Instructions De Montage Et De Service

Operation

➤ Screw the lock tight again and put the panel back on.
➤ Fasten the board again and put the mattress back on.
✓ Installation is complete.
7 Operation
I
NOTE
Empty the cool box and switch it off before tilting the cab.
7.1

Before initial use

I
NOTE
Before starting your new cooler for the first time, you should clean it
inside and outside with a damp cloth for hygienic reasons
(see "Cleaning and care" on page 13).
7.2

Energy saving tips

• Allow hot food to cool down first before you place it into the device.
• Do not open the cooler more often than necessary.
• Do not leave the cooler open for longer than necessary.
• Avoid unnecessarily low temperature settings.
7.3

Using the cooler

A
NOTICE! Danger of overheating
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
A
NOTICE! Danger from excessively low temperature
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
➤ Switch on the cooler on by turning the temperature control knob to the right.
✓ The cooler starts cooling the interior.
12
CSMP2
EN