Rear Panel Features - Numark V7 Guide D'utilisation Rapide

REAR PANEL FEATURES

1. POWER IN – Use the included power cable to connect V7 to a power outlet. While the power is switched off, plug the
cable into V7 first, then plug the cable into a power outlet.
2. POWER SWITCH – Turns V7 on and off. Turn on V7 after all input devices have been connected and before you turn
on amplifiers. Turn off amplifiers before you turn off V7.
3. USB – This USB connection sends and receives audio and control information from a connected computer.
4. DECK A / DECK B OUTPUT (RCA) – Use standard RCA cables to connect these outputs for Deck A and Deck B to the
left and right channels (respectively) of your mixer.
5. MOTOR TORQUE – Flip this switch to adjust the torque of the PLATTERS. At the high setting, the PLATTERS will have
the heavier, stronger feel of "modern" turntables. At the lower setting, they are lighter and more graceful – the feel of a
"classic" turntable.
6. REMOTE – If you are using a "fader start"-compatible mixer, you can start and cue music automatically on the V7 by
moving the mixer's crossfader towards it. To use fader start, connect the V7's REMOTE output to your fader start-
compatible mixer with standard 1/8" cables.
7. LINK CONNECTION – If you are using two V7s, connect their LINK CONNECTIONS with the included link cable.
8. DECK LOCATION SWITCH – Reserved for future use.
TOP PANEL FEATURES
9
14
10 11 12 13
15 16 17 18
21
5
6
20
35
37
36
7
38
AC IN 100V-240V
50-60Hz 50W
POWER
2 1
19
26
1
8 8 8 8
4 3 2
USB LINK DECK REMOTE MOTOR
LOCATION TORQUE
RIGHT LEFT HIGH LOW
5
3 7 8
6
28
29 29
30 31 32
33 34 33
40 41
39
42
22
23
27
24
27
8
25
3
DECK B DECK A
L L
4
R R
OUTPUT
USEFUL TERMS:
Audio Pointer:
current position in a track
from where audio will play.
When you select a track
and begin playing,
Audio Pointer will usually
start from the beginning and
stop at the end.
Cue Point:
position in a track, which
will be permanently stored
by the software.
set, return to, or delete Cue
Points with
CONTROLS.
Temporary Cue Point: A
marked position in a track,
which will only remain while
that track is still loaded in
the Deck. You can set and
return to the Temporary
Cue Point with the CUE
button.
The
the
A marked
You can
the CUE