Removing The Transport Protection; Changing The Door Hinge - Dometic MR07 Instructions De Montage Et De Service

Installing and connecting the device
No. in fig. 4,
page 3
1
2
3
4
➤ Fix the device with eight screws (fig. 5 1, page 3).
6.3

Removing the transport protection

The device has a locking mechanism to protect it during transport. The following
settings are possible (fig. 6, page 4):
• Position 1 (transport lock): (1). The door is locked and secured. To open the door,
turn the bolt to position 2.
• Position 2: (2). The door can be opened.
• Position 3 ("VENT" position): (3). The door is slightly open, but fixed in position.
Use this position, for example, if you are not going to use the device for a long
time.
6.4

Changing the door hinge

You can also change the hinge of the door, so that it opens to the left rather than the
right.
To change the door hinge, proceed as follows (fig. 7, page 4):
➤ Remove the upper door hinge (1).
➤ Carefully lift out the door.
➤ Remove the threaded pins (2).
➤ Pull the locking hook (3) off the rod.
➤ Remove the locking plate (4) and fit it on the opposite side.
➤ Pull the rod downwards and out and put it in the other side.
➤ Fasten the locking hook (3) back on the rod.
➤ Detach the top and bottom lock holders (5) on the left side.
➤ Detach the top and bottom door hinges (1) on the right side.
12
Explanation
Hot waste air
Cold intake air
Condenser
With decorative panel 50 mm space at the top!
MR07, MRR07, MH07
EN