MC302, MC502
A slight layer of frost or water droplets could form in the interior of the refrigerator if
it has been cooling for longer periods. This is normal because the moisture in the air
condenses to water when the temperature in the refrigerator drops. The refrigerator
is not defective.
The condensate flows out through a water drain duct into a water container at the
back of the refrigerator at top of the compressor, where it evaporates.
It is recommended to defrost the refrigerator every three weeks.
Proceed as follows:
1. Switch off the refrigerator: press the
2. Disconnect the refrigerator from the mains.
3. Remove the drawers (see chapter "Removing the drawers" on page 21).
4. Leave the door open.
5. After defrosting wipe out the cabinet interior with a clean, damp cloth.
6. Assemble the drawers.
7.10
Switching off and storing the refrigerator
If you do not intend to use the refrigerator for a long time, proceed as follows:
1. Switch off the refrigerator: press the
2. Disconnect the refrigerator from the mains.
3. Clean the refrigerator (see chapter "Cleaning and maintenance" on page 22).
4. Leave the door slightly open.
This prevents smells from building up.
7.11
Removing the drawers
You can remove the drawers, e.g. for cleaning.
Proceed as follows (fig. 0, page 7):
1. Open the door (A).
2. Pull out the drawer (B).
3. Push the fixing pins from the outside to the inside (C).
4. Remove the drawer (D).
5. Assemble the drawers in reverse order.
EN
button for more than 5 seconds.
button for more than 5 seconds.
Operation
21