Safety instructions
A
NOTICE!
Failure to observe this instruction can cause material damage and impair
the function of the product.
I
NOTE
Supplementary information for operating the product.
2
Safety instructions
The manufacturer accepts no liability for damage in the following cases:
• Damage to the product resulting from mechanical influences and incorrect
connection voltage
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in the operating manual
2.1
General safety
!
WARNING!
• Before you start up the appliance for the first time, check that the
operating voltage matches the battery voltage (see type plate).
• If the cable is damaged, it must be replaced to prevent possible
electrical hazards. Only replace a damaged cable with one of the
same type and specifications.
• Have a trained technician perform the installation in wet rooms.
• Do not operate the appliance if it is visibly damaged.
• This appliance may only be repaired by qualified personnel.
Inadequate repairs can cause considerable hazards.
If you device should need repairing, please contact customer service.
A
NOTICE!
• Do not open the refrigerant or caloric circuit under any circumstances.
• Set up the appliance in a dry location where it is protected against
splashing water.
• Do not mount the device near other heat sources (heater, strong direct
sunlight, gas ovens, etc.)
• Ensure that the ventilation slots are not covered.
8
MR07, MRR07, MH07
EN