Fitting Up And Removing The Handle; Fitting Up The Handle; Removing The Handle; Customer Service - Dometic miniCool DS 200 Mode D'emploi

Masquer les pouces Voir aussi pour miniCool DS 200:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
Place back the forehead panel,rosette and screw in
reverse sequence.
11. Fitting up and removing the
handle
(If available)
The handle which can be found among the
accessories of the appliance should be fitted and
removed as follows:

11.1. Fitting up the handle

11.2. Removing the handle

12. Positioning of the shelf
Pull out the storage rack until it is blocked.
Press in the lock of both running rails.
Remove storage rack and running rails and place it
at the desired position.
After clicking in the the storage rack it is secured
against pulling out completely again

13. Customer service

Before you call a service engineer, carry out the
following simple tests:
Problem
The appliance does not cool sufficiently
The appliance does not cool at all and the
LEDs are flashing
The appliance does not cool at all and
there is no lighting at all
When checking all the above points and the
refrigerator is still not working satisfactorily, contact
your nearest service engineer. State the problem,
model, product- and serial-number.
(Details of the model, product- and serialnumber are
to be found on the data label in the top left of the
inside compartment.)
In the event of a fault developing, contact your nearest
Service Centre-see local telephone directory.
www.dometic.com

14. Putting into operation

Technical data:
Model
DS 200
Type
DS20-60
Gross volume
23 litre
Mains operation
220 - 240V (AC)
Input
65W
Energy consumption 0.740 kWh/24h
Climate class
SN
Absorber Solution
147g H
(fig. 12., 13.)
(fig. 14.)
(fig. 15.)
Thermostat control is set too low.
Too much food to be cooled was put in.
Door is not shut properly.
Internal air circulation is restricted.
CUC system stopped the operation.
Plug is not connected to the mains socket properly
There is no voltage in the mains socket.
DS 300
DS20-60
28 litre
220 - 240V (AC)
65W
0,755 kWh/24h
SN
O + 98 g NH
151g H
O + 101 g NH
2
3
2
Possible cause
DS 400
DS20-60
34 litre
220 - 240V (AC)
65W
0.760 kWh/24h
SN
151g H
O + 101 g NH
3
2
3
Solution
Set to a higher position.
Put in less food to be be cooled.
Check if the door is shut.
Provide inside cool air circulation.
See operating instruction 5.3.
Check if the connection is proper.
Check if there is voltage.
DS 600
DS20-60
45 litre
220 - 240V (AC)
65W
0.765 kWh/24h
SN
157g H
O + 105 g NH
2
3
GB
9

Publicité

Table des Matières
loading

Table des Matières