Beko MAT 13 Instructions De Montage Et De Service page 5

Caution!
Malfunctions in the application!
which is not discharged can lead to damage to plants and in manufacturing processes.
Measures:
• Fail-safe condensate discharge directly optimises the compressed-air quality.
• To prevent damage and failures, it is imperative
• To comply with the provisions regarding proper use and with the operating parameters of the BEKOMAT
with the case of application (see chapter "Proper use").
• To strictly adhere to the installation and operating advice in these instructions.
• To maintain and check the BEKOMAT
tions.
Proper use
®
• The BEKOMAT is an electronically level-controlled condensate drain for compressed-air plants.
• It is employed within the permissible operating parameters (see "Technical data").
®
• The BEKOMAT is able to drain condensate under operating pressure from the plant components virtually without com-
pressed-air losses.
• For its function, the BEKOMAT
• As far as the employment in plants with increased demands on the compressed-air quality is concerned (food industry, medi-
cal technology, laboratory equipment, special processes etc.), the operator must decide on measures for the monitoring of
the compressed-air quality. These have an effect on the safety of the subsequent processes and may prevent damage to
persons and plants.
• It is the task of the operator to ensure that the indicated conditions are met during the entire operating time.
• For the employment in CO
• The BEKOMAT ® and the condensate supply line need to be protected against frost, as otherwise the function cannot be
guaranteed. BEKO TECHNOLOGIES GMBH also offers suitable products for this purpose.
• The additional control allows the user to externally actuate the BEKOMAT
to monitor the valve switching cycles via a potential-free contact (relay K2).
• The BEKOMAT ® as a condensate drain alone cannot
additional technical devices are required.
®
• BEKOMAT 13 is not suitable for use in plants carrying vacuum or atmospheric ambient pressure or in hazardous areas.
• The BEKOMAT ® must not be exposed to permanent direct solar or thermal radiation.
• BEKOMAT ® 13 must not be installed and operated in areas with an aggressive atmosphere.
BEKOMAT 13 | 13 CO | 13 CO PN25 | 13 CO PN40
® at regular intervals in accordance with the advice in these operating instruc-
® 13 requires an operating voltage and an operating pressure (see "Technical data").
plants, a BEKOMAT ®
2
®
can malfunction. Condensate
® ... CO) must be used.
®
valve with a 24 V control voltage (relay K1), and
® in connection
5