Installation; Before The Installation; Connection Cable - Electrolux EHF6547FOK Notice D'utilisation

Problem
The sensor fields become
hot.
There is no signal when
you touch the panel sensor
fields.
comes on.
comes on.
and a number come on. There is an error in the
E6 comes on.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass

8. INSTALLATION

WARNING!
Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................
Possible cause
The cookware is too large
or you put it too near to the
controls.
The signals are deactiva‐
ted.
Automatic Switch Off oper‐
ates.
The Child Safety Device or
the Lock function operates.
hob.
The second phase of the
power supply is missing.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
8.2 Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.

8.3 Connection cable

• The hob is supplied with a connection
cable.
ENGLISH
Remedy
Put large cookware on the
rear zones if possible.
Activate the signals.
Refer to "Daily use" chap‐
ter.
Deactivate the hob and ac‐
tivate it again.
Refer to "Daily use" chap‐
ter.
Disconnect the hob from
the electrical supply for
some time. Disconnect the
fuse from the electrical
system of the house. Con‐
nect it again. If comes
on again, speak to an Au‐
thorised Service Centre.
Check if the hob is correct‐
ly connected to the electri‐
cal supply. Remove the
fuse, wait one minute, and
insert the fuse again.
31