Witter VW53A Instructions De Montage

Les langues disponibles

Télécharger ce manuel

Fitting

Instructions

MATERIALS

Cross Bar with European facing to 94/20/EC A50-1

ZEP35 Electrical plate (not shown)

M16 x 50mm Coupling Bolts, Nuts, Lock Washers

FITTING

1. Remove Bumper, 4 tip screws in each wheel arch, 4 Tip screws along lower edge of bumper and 2 Tip screws under

each light cluster. (Note: Light cluster is held on by means of a plastic ball and socket type clip. To release clips pull light

cluster rearward, take care not to crack. Do not use any type of trim removal tools as a lever, lamps can crack easily.

2. Remove crash beam, retain fixings (X) for fitting of towbar.

3. Attach crossbar (A) using existing bolts (X)

4. Cut bumper as shown and refit.

Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally

Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.

Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.

Recommended torque settings: Grade 8.8 M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm

WITTER TOWBARS

Deeside Ind. Park, Deeside, CH5 2NY witter-towbars.co.uk

Grade 10.9 M12 – 139Nm

W0001VW53A-FIT$011103170000oÄ

W0001VW53A-FIT$011103170000

TOWBAR

For Volkswagon Touareg

June 2003 –

VW53A

Issue 1

Page 1 4. Cut bumper as shown and refit. Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally Conforming to A50-1 with a ‘D’ and 'S' value greater than or equal to that of the towbar.
Page 2 4. Découper le pare-chocs et le réinstaller (voir illustration). Remarque : Cet attelage doit être utilisé avec une boule de remorquage Witter (référence produit Z11) ou une boule de remorquage Classe A50-1 ou A50-X se conformant dimensionnellement Conforme à A50-1 avec une valeur ‘D’ et 'S' supérieure ou égale à...