Drainage
1. Turn off all the buttons on the control panel.
2. Unscrew the valve on outside of the spa pool till it is detached from the drainage structure.
3. Connect the black drainage hose on to the drainage structure.
Make sure it is well connected and the other end of the drainage hose is connected to a ground drain.
4. Pull and open the cover of the drainage structure inside of the spa pool, water will flow out from the
drainage hose.
5. Tilt the spa until no water flow out to empty the spa completely.
If you are going away for some weeks and nobody can follow up the water treatment
program in your MSpa, please drain out the water before leaving and take out some
air pressure.
Spa Pool Repair
If the Spa is torn or punctured use the provided Repair Patch. Dry the area to be repaired. apply the glue
for PVC to PVC to the repair patch and then attach it onto the damaged area. Smooth the surface to
remove any air bubbles. A secure unnoticeable repair can usually be made.
Spa Storage
After the spa is drained, unscrew the complete part of the air valve on the spa pool and the spa will be
deflated.
Make sure all water is drained from the Spa and control box. This is essential to extend the life of the spa.
We recommend the use of a wet/dry vacuum to blow out or suck up water from the Spa pipes and Pump
lines. Remove the Filter Cartridge. It is recommended you store the spa in its original package in a warm
dry place.
NOTE: Make sure all components are completely dry and clean before re-packing.
Store safely in dry condition and out of sunlight.
Plastic becomes brittle and susceptible to breakage when exposed to subzero temperatures.
Freezing can severely damage the Spa. Improper winterization of your Spa may void your warranty.
Spa checklist before unpack the unit and re-use for the new season:
In order to have your MSpa runs smoothly and easily for another new season, make sure you do the follow:
1. Check if there is water in the air pipe. If any water is found, dry the air pipe before operating the spa tub.
2. Connect control panel correctly, turn on the spa tub, check if LED displays correctly and if the signal cable
is connected properly.
3. Press ON / OFF button on the control panel, open bubble function, check if it operates properly.
4. After doing the above steps, your MSpa should be ready for use. Enjoy it!
Any damage caused by improper storage or failure to do the checklist of reuse will void your warranty.
1.The marking
indicates that this product shall not be disposed with the general household waste.
Please contact your local community about collection points or ask your dealer.
2.This product contains valuable materials that can be recycled and contribute to a sustainable
enviroment.
3.For recovery, recycling and dismantling information for this product, please visit us at
www. the-mspa. com
DISPOSAL
13