mspa Nest B-100 Guide De L'utilisateur page 11

Masquer les pouces Voir aussi pour Nest B-100:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

LED Display: Once powered-up, the LED displays the current water temperature automatically.
NOTE: The setting temperature defaults to 38°C (100°F) when first plugged in.
NOTE: Temperature adjustment ranges from 20°C (68°F) to 40°C (104°F).
Set your desired temperature by pressing "TEMPERATURE" Button.
Note: In case when leaving spa under unattended working condition, you can press up " " &. down " "
buttons at the same time to lock the conttrol panel to avoid any misoperation by children. To press both
buttons at the same time again and after hearing sound of "DI", it will be unlocked.
The light of the "HEATER" button displays red when the heating system is activated.
Note: It's normal that filtration system cannot be turned off individually when heating system is working.
And filtration system can only be turned off by pressing "HEATER" button but not "FILTER" button
The heater does not stop heating the Spa until the current water temperature reaches the setting
temperature. Then the "FILTER" button will be off and the light of "HEATER" button displays green.
After the current water temperature drops 2°C(4°F) below the set point temperature, the heating system
will restart and light turns into red. The "FILTER" button will be activated automatically at the same time.
The heat increase rate is maximumly 1.2 to 1.7°C(1-3°F) per hour.
Please note that the following conditions will lead to slow and even heating without heating phenomenon:
1. Environmental temperature lower than 10°C(50°F)
2. Outdoor wind force above Gentle breeze/F 3
3. Environmental temperature lower than 10°C(50°F) and wind power above Gentle breeze/F 3
4. Activate bubbling system when heating
5. Spa lid is not covered or improperly covered when heating
6. In order to conform to the safety regulations, MSpa control system uses double heating elements
technology. When bubble+filter+heater functions are all on, only one heating element is working,
which is of 675W only
So you are recommended to fill spa with warm water for quick heating and energy
saving.
For B-150, when heating, please always remember to use inflatable bladder & heat mat,
for quicker and better heating performance.
Maintaining Spa Water
Poor water quality can be extremely hazardous to your health.
We recommend you do following things:
A: Please use filter cartridge.
Screw the filter onto the water inlet(lower fitting) on the spa wall by turning it clockwise.
Note:
Two filter cartridge, one is for use, one is spare.
Note: Do not use filter cartridge when only to heat water and to ensure
good heating performance. To avoid that the filter cartridge get damaged,
you take it off when there are children in the pool or more than two persons.
After finish bathing replace the filter cartridge.
B: Clean your filter cartridge at least once a time after it worked continuously for 72~120 hours. The filter
cartridge should be replaced at least once a week depending on use.
Please make sure to unplug the power pack from the
electrical receptacle before the following actions.
1. Unscrew the filter cartridge by turning it counterclockwise.
2. The Filter Cartridge can be rinsed off with a garden hose
and reused. However, if the Filter Cartridge remains soiled
and discolored the Filter Cartridge should be replaced .
11
(1)
(A)
(2)

Publicité

Table des Matières
loading

Table des Matières