Telephone Installation - Funkwerk elmeg CS290 Instructions De Service

place them back in the enclosure. By turning the feet by around 60° (around the longitudinal
axis) each time you can set three different heights for the phone.
Please note that the plastic feet of your telephone may leave marks on sensitive surfaces, such as
furniture. The manufacturer of the telephone is not liable for any such damage. Therefore, use
appropriate non-skidding pads under the phone.

Telephone installation

Connecting the handset cord
Connect the handset cord
and lock it below the two cord retainers
elmeg CS290 at the ISDN port
1
2
6
Figure: 2
elmeg CS 290-U at the UP0-port
Figure: 3
CS290-U phones may not be connected through the S0 jack to the ISDN connection.
Important notes for the UP0-connection
An ISDN terminal device equipped with S0-port can be connected to the phone's S0-jack.
•
The maximum line distance between the elmeg CS290-U and any downstream ISDN ter-
•
minal devices may not exceed 10 meters.
1
as shown in figure 2. Lay the handset cord in the cord groove
3
.
3
6
Connect the ISDN-cord
shown in figure 2. Ensure that the longer ISDN
connector is plugged into the ISDN jack and the
shorter ISDN connector into the ISDN socket on
the telephone. Then lay the ISDN cord in the cord
2
groove and lock it below the two cord retai-
3
ners .
Connect the ISDN-cord
shown in figure 3. Ensure that the longer ISDN
connector is plugged into the ISDN jack and the
shorter ISDN connector into the ISDN socket on
the telephone. Then lay the ISDN cord in the cord
2
groove and lock it below the two cord retai-
3
ners . Figure 3 shows a downstream ISDN-te-
lephone connected to the S0--port of the elmeg
290-U.
2
1
to the S0-jack as
1
to the UP0jack as
5