Advanced System Telephone Configuration - Funkwerk elmeg CS290 Instructions De Service

Pictographs
Thepictographs(symbols)describedbelowhavebeenusedintheseoperatinginstructionstoil-
lustrate some procedures for setting and using the telephone.
b
Lift up the handset or start prepared dialing.
a
Replace handset.
The telephone is idle.
l
A call is signaled.
The ringer melody sounds.
g
You are conducting a call.
d
A three-party conference call is initiated.
q
You hear the positive or negative acknowledgement signal.
t
Select the call number, code, character or text.
0 9
...
Press the appropriate button on the push-button set.
* #
,
#
When you enter the number for dialing via an SIP provider, dialing is not per-
formed until around 5 seconds after the last digit has been entered. Dialing is
performed immediately when you press the # key after entering the number.
In this case, the terminal device must also be capable of dialing into the phone
system with the #.

Advanced system telephone configuration

In general, your telephone allows for a limited configuration only of the supported features.
Complete configuration is possible only using an elmeg PABX system.
Activating the extended configuration mode
Enter the code number »**46782551##« (Vanity-format »**INSTALL1##«).
Release for remote access of the phone is effected for 30 minutes.
Advanced Settings
Entering or modifying MSN extension numbers
F
Under - »
config
numbers.
Connected to a pabx
F
Begin as follows:
Number length (softkey »
•
The maximum length for internal numbers that are assigned to different internal exten-
sions within your PABX system;
« - » « - » ...3« - »
msn msn-1
» «-» «
config pabx
«)
number
« - you can enter and edit the phone
tnumb
9