Declaration Of Conformity - Bosch PKS 54 Notice Originale

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until Dec. 28, 2009),
2006/42/EC (from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
08.01.2008, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly
Mounting/Replacing the Saw Blade
Before any work on the machine itself, pull
the mains plug.
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Only use saw blades that correspond with
the characteristic data given in the operat-
ing instructions.
Do not under any circumstances use grind-
ing discs as the cutting tool.
Selecting a Saw Blade
An overview of recommended saw blades can
be found at the end of this manual.
Bosch Power Tools
Dr. Eckerhard Strötgen
Head of Product
Certification
Removal of the Saw Blade (see figure A)
For changing the cutting tool, it is best to place
the machine on the face side of the motor hous-
ing.
– Press the spindle lock button 5 and keep it
pressed.
The spindle lock button 5 may be actuated
only when the saw spindle is at a standstill.
Otherwise, the power tool can be damaged.
– With the Allen key 6, unscrew the clamping
bolt 19 turning in rotation direction
– Tilt back the retracting blade guard 13 and
hold firmly.
– Remove the clamping flange 20 and the saw
blade 21 from the saw spindle 23.
Mounting the Saw Blade (see figure A)
For changing the cutting tool, it is best to place
the machine on the face side of the motor hous-
ing.
– Clean the saw blade 21 and all clamping
parts to be assembled.
– Tilt back the retracting blade guard 13 and
hold firmly.
– Place the saw blade 21 on to the mounting
flange 22. The cutting direction of the teeth
(direction or arrow on saw blade) and the di-
rection-of-rotation arrow on the blade guard
17 must correspond.
– Mount the clamping flange 20 and screw in
the clamping bolt 19 turning in rotation di-
rection . Observe correct mounting posi-
tion of mounting flange 22 and clamping
flange 20.
– Press the spindle lock button 5 and keep it
pressed.
– With the Allen key 6, tighten the clamping
bolt 19 turning in rotation direction
tightening torque is between 6–9 Nm, which
corresponds to hand tight plus ¼ turn.
English | 25
.
. The
1 609 929 N30 | (4.2.08)