Troubleshooting - AYA ACT1002WA Instructions D'utilisation

BEFORE contacting a service agent, check the following points:
Symptom
No power to the appliance
The temperature in the freezer
section is too high
The freezer door will not open
The compressor runs continuously
Excessive frost and ice has built up
Noise
If after the above checks there is still a fault, contact Customer Support for assistance.
In warranty customers should ensure that the above checks have been made before
sending for repair, as fees may be levied if the fault is not a mechanical or electrical
breakdown.

TROUBLESHOOTING

Solution
Check that there is power at the socket.
Check that the fuse has not blown.
Check that the ambient temperature is within the
freezer's operating limits of 16 c to 32 c.
Relocate the appliance if necessary .
Check that the thermostat is turned to the correct
setting, relative to ambient conditions.
If the door has just been opened, you may need to
wait a minute or two for the pressure. to equalise.
Make sure that the thermostat is not set to "Super" .
See " Thermostat Control" on page 5 for details.
Check that the door is closed properly and that the
door seals are intact and clean.
Large quantities of food have recently been placed
in the freezer and /or the door is frequently opened.
Check that sufficient ventilation is available. See
"Ventilation Requirements" on page 11 for details.
Ensure the door is not left open.
Check that nothing is preventing the door from closing.
Check that the door gasket (seal) is intact and clean.
Defrost the freezer as described on page 8 (" See
To Defrost the Freezer ").
Refer to Normal Operating Sounds on page 7.
9
O O O O