Before Use; Thermostat Controls; Using The Appliance; To Start The Appliance - AYA ACT1002WA Instructions D'utilisation

This appliance is designed for
domestic use only, specifically for the
storage of edible foodstuffs.
This appliance is designed to operate in
ambient temperatures (surrounding air
temperature) between 16 C and 32 C.
Outside this temperature range, the freezer
may not operate correctly . Should the a-
mbient temperatures be exceeded for long
periods, the temperature in the freezer
section will above -18 C and food spoilage
may occur.

Before Use

Remove all securing tapes.
Wash the inside of the appliance with
lukewarm water with a little bicarbonate of
soda added (5ml to 0.5 litre of water). Do not
use soap or detergent as the smell may linger .
Dry the appliance thoroughly .
Thermostat Control
The thermostat control situated in the control
panel regulates the temperature of the
freezer compartment.
Position "Min" -Cold
Position "Normal" - Colder. This setting is
generally most suitable for everyday use.
Position "Max" - Coldest
Position "Super" -To fast freeze a quantity of
unfrozen food, the compressor works
continuously in this mode.
See "Freezing Fresh Food" on page 6 for
details. The temperature will be affected by:
Room temperature
How often the door is opened
How much food is stored
Position of the appliance
In determining the correct temperature
control setting for your situation, all these
factors have to be considered, and some
experimentation may be necessary .
Do not allow children to tamper with the
controls or play with the product.

USING THE APPLIANCE

O O
O
Do not use detergents, abrasive
powders, highly perfumed cleaning
products, wax poblishes or products
containing alcohol.

To Start the Appliance

1.Allow the appliance to stand for 2 hours 1.Allow the appliance to stand for 2 hours
after installation. after installation.
2.Plug in the appliance and switch on at the 2.Plug in the appliance and switch on at the
m ains supply. m ains supply.
3.Turn the thermostat control to the required 3.Turn the thermostat control to the required
setting. A midway setting is usually suitable setting. A midway setting is usually suitable
for normal operation (see thermostat control). for normal operation (see thermostat control).
4.Leave the appliance for approximately 4 hours 4.Leave the appliance for approximately 4 hours
for the correct temperature to be reached for the correct temperature to be reached
before placing food inside. before placing food inside.
MIN
5
NORMAL
MAX
SUPER