Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To reduce the risk of injury, always unplug
tool before attaching or removing accessories
or making adjustments. Use only specifically
recommended accessories. Others may be
hazardous.
Removing and Replacing Quik-Lok Cords (Fig. 1)
MILWAUKEE'S exclusive Quik-Lok Cords provide instant fi eld replace-
ment or substitution.
Fig. 1
1.
To remove the Quik-Lok Cord, turn the cord nut 1/4 turn to the left and
pull it out.
2.
To replace the Quik-Lok Cord, align the connector keyways and push
the connector in as far as it will go. Turn the cord nut 1/4 turn to the
right to lock.
To reduce the risk of injury, always use a side
handle when using this tool. Always brace or hold
securely.
Adjusting the Side Handle (Fig. 2)
Fig. 2
Side handle
1.
Loosen the side handle slightly by unscrewing it counter-
clockwise.
2.
Rotate the side handle to the required angle.
3.
Tighten the side handle securely.
WARNING
WARNING
TOOL ASSEMBLY
Installing Bits and Chisels (Fig. 3)
SDS Max Drive System (Cat. No. 5315-21)
The 5315-21 Rotary Hammer uses SDS max drill bits and hammer steel
chisels.
Fig. 3
1.
Insert the bit or chisel into the nose of the tool.
2.
Rotate bit slowly until it aligns with the locking mechanism.
3.
Push bit into tool until it locks.
4.
Check to see that bit is locked by tugging on it.
5.
To remove bits and chisels, pull bit release collar (1) toward the rear of
tool and remove bit.
NOTE: Use caution when handling hot bits and chisels.
Installing Bits and Chisels (Fig. 4)
Spline Drive System (Cat. No. 5319-21 & 5321-21)
The 5319-21 and 5321-21 Rotary Hammers use carbide bits with spline
shanks and hammer steel chisels with round hex shanks.
Fig. 4
1.
Insert the bit or chisel into the nose of the tool.
If you are using a rotary bit, make sure that the splines on the shank
engage with the splines inside the nose of the tool.
If you are using a chisel, make sure that the notch in the shank faces up
(Fig. 4).
2.
Push bit into tool until it locks.
3.
Check to see that bit is locked by tugging on it.
4.
To remove bits and chisels, pull bit release collar (1) toward the rear of
tool and remove bit.
NOTE: Use caution when handling hot bits and chisels.
1
Bit with SDS max shank
1
Rotary bit with spline shank
Chisel with round hex shank
page 5
Publicité
Table des Matières
