Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To reduce the risk of injury, always unplug tool before
attaching or removing accessories or making adjustments.
Use only specifically recommended accessories. Others
may be hazardous.
Adjusting the Side Handle (Fig. 1)
Fig. 1
1.
Loosen the side handle slightly by unscrewing it counterclockwise.
2.
Rotate the side handle to the required angle.
3.
Tighten the side handle securely.
To reduce the risk of injury, always use a side handle when
using this tool. Always brace and hold securely.
The side handle can be used at the rear of the tool. Remove the handle
and install it in one of the positions provided on either side (1). Use the
side handle knob in the front handle position to secure the depth gauge
assembly.
Installing Bits and Chisels (Fig. 2)
Spline Drive System (Cat. No. 5345-21)
The 5345-21 Rotary Hammer uses carbide bits with spline shanks and
hammer steel chisels with round hex shanks.
Fig. 2
Rotary bit with spline shank
Chisel with round hex shank
1.
Insert the bit or chisel into the nose of the tool.
If you are using a rotary bit, make sure that the splines on the shank
engage with the splines inside the nose of the tool.
If you are using a chisel, make sure that the notch in the shank faces
toward the bit lock.
WARNING!
1
WARNING!
TOOL ASSEMBLY
2.
To lock, push the bit lock to the right as shown.
3.
To unlock, push the bit lock to the left as shown.
NOTE: Use caution when handling hot bits and chisels.
Installing Bits and Chisels (Fig. 3)
SDS Max Drive System (Cat. No. 5346-21, 5346-28)
The 5346-21 and 5346-28 rotary hammers use SDS max drill bits and
hammer steel chisels.
Fig. 3
1.
Insert the bit or chisel into the nose of the tool.
2.
Rotate bit slowly until it aligns with the locking mechanism.
3.
Push bit into tool until it locks.
4.
Check to see that bit is locked by tugging on it.
5.
To remove bits and chisels, pull bit release collar (1) toward the rear
of tool and remove bit.
NOTE: Use caution when handling hot bits and chisels.
Setting the Depth Gauge (Fig. 4)
1.
Loosen the depth gauge adjustment knob (2).
2.
Slide the depth gauge rod (1) backward or forward until it is set for
the desired depth. The drilling depth is the distance between the tip
of the bit and the tip of the depth gauge rod.
3.
Tighten the depth gauge adjustment knob securely.
1
Bit with SDS max shank
Fig. 4
1
2
page 5
Publicité
Table des Matières
