Mediclinics M092A Manuel D'installation Et D'utilisation page 17

www.mediclinics.com
B – Connect the earth terminal.
IR SENSOR WIRE CONNECTION AND CASING CLOSE
A – Connect the sensor IR wire to the electronic board.
B – Route the wire inside the plastic protector and place it in the casing.
C - Carefully place the casing on the base of the device. To do so place it over the
base with a slight incline from top to bottom, in such a way that the tab in the casing
correctly inserts into the corresponding slot in the base.
D - Place the washer, the earth wire and the screws for fixing the casing to the base,
fixing them tightly using the special spanner provided. Confirm the earth terminal is
firmly installed, not loose or detachable.
17