hager S771-22X Guide D'installation page 128

Receiver programming
• Use the programming key to programme the following sequence:
LED
once and hold
press key
(10 s approx.)
configuration
sequence
1) To start
the sequence,
press and hold
the key until
the LED goes out
• Example of configuring the external receiver in Timer mode:
To change the external receiver configuration to Timer mode for a 15-minute duration, proceed as follows:
G
B
1) Start
If you make a programming error, the programming LED will flash quickly. You must carry out the programming sequence again
from the start.
........ times*
(5 s approx.)
2) Press the key
as many times and hold
as the parameter the key until
number
2
2) Press twice to select 3) Press once to
the Timer application accept selection
once
........ times*
and hold
3) Press 4) Press the key
as many times as
the parameter value
the LED
goes out
5
4) Press the key 5 times
to select the 15 min. period
128
once and hold
* Make a note
(10 s approx.)
of the chosen
parameter
number/value
LED permanently
5) To end
the sequence, ON for 2 sec.
press and hold
the key until configuration correct
the LED goes out
5) End
=