Installation; Choosing The Best Place; Standard Fixing Method; Fixing The Receiver On A Wall Box (Indoor Use Only) - hager S771-22X Guide D'installation

Installation

Choosing the best place

The external receiv-
er must be placed
with the cables
pointing downwards
and according to the standard fix-
ing method for outside installation.
The external receiver must not
be placed:
• directly on a metal wall,
• less than 1 metre away from a
water pipe,
• too close to the appliance to be
controlled if it is likely to generate
interference (neon lighting, etc.).

Standard fixing method

Put the fixing
plate in the place
where it is to be
installed and mark
G
the position of the
B
fixing points.
Example
of fixing points
¡ Drill the holes with a 6 mm Ø
drill bit.
¬ Fix the plate using the appropri-
ate wall plugs and screws.
√ Adjust ver ticality using the
washer.
Hook the base of the external
ƒ
receiver on to the fixing plate and
fasten it in position using the screw
provided (bag).
Hooks
Switch off the mains 230 V
power supply before carrying out
Risk of electric
work on the electrical system.
shock
120
Fixing the receiver
on a wall box
(for inside installation only)
Thread the cables through the
holes in the plate and then through
the holes in the base membranes.
Fix the plate in
¡
position using the
box screws:
- for a Ø 60 mm box
Fixing points
- for a Ø 85 mm box
Screw
Fixing
points