Recognition Programming; Remote Control Or Keypad (Other Than A Multi-Functional Mobile Keypad) Recognition Programming - hager S771-22X Guide D'installation

Recognition programming

It is possible to programme the external receiver to be
recognised by a maximum of 15 control devices
(remote controls or keypads). A control device can con-
trol an unlimited number of receivers. Recognition pro-
gramming must be performed for each external receiv-
er in this case.
Recognition programming must be performed
with the device to be controlled de-activated
(receiver LED off).
Remote control or keypad (other
than a multi-functional mobile
keypad) recognition programming
First programme the chosen key for one of the follow-
ing commands (see keypad or remote control installa-
tion guide):
• Light ON,
• Light OFF,
• Relays 1, 2, 3 or 4 ON,
G
• Relays 1, 2, 3 or 4 OFF
B
• Light in timer mode,
• Relays 1, 2, 3 or 4 in timer mode,
• Light in toggle switch mode,
• Relays 1, 2, 3 or 4 in toggle switch mode.
Perform programming as follows:
Press the
external receiver
programming
key (for less
than 2 sec.).
The programming
LED will light
up temporarily.
If you make a programming error, the programming
LED will flash quickly. You must carry out the program-
ming sequence again from the start.
124
Press and hold
the programmed external receiver
key on the remote confirms
control or keypad
programming
until the external
receiver
programming
programming LED
LED lighting
lights up.
up for 2 sec.
The
by its