Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. How to control the fixture
You can operate the unit in two ways:
1. By master/slave built‐in preprogram function
2. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be affected at once.
DMX Controller
Using a universal DMX controller to control the units, you have to set DMX address from 1 to
512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
button and the display will blink. Use UP and DOW N button to change the DMX512 address.
Once the address has been selected, press and keep ENTER button pressed up to when
the display stops blinking or storing automatically 7 seconds later. To go back to the
is showing on the display. Press ENTER
10
Publicité
Table des Matières
