Basic Settings; Initial Settings; Setting The Clock; Hiding / Displaying The Clock - F.Bertazzoni PROCS30X Guide De L'utilisateur

Basic settings

Initial Settings

After your steam oven is first plugged in or after a
power failure, the clock display will flash to
indicate that the time shown is not correct.
The oven will not operate until the clock and the
water hardness parameter is set.

Setting the clock

Before using the oven, adjust the clock through the procedure described below but starting on Step 3.
To set the clock, proceed as follows:
1. Press the "+" key until the Clock Indicator
Light starts to flash.
2. Press the OK key.
3. Press the "+" and "-" keys to set the correct
hour value.

Hiding / Displaying the Clock

If the clock display disturbs you, you can hide it by proceeding as follows:
1. To block, the oven press the "+" key and the
"-" key simultaneously for 5 seconds. The
dots that separate the hours and minutes
and the clock symbol will flash, but the rest
of the clock display will be hidden.
To set the clock and the water hardness
parameter value proceed as described in the
following chapters:
1, 3, 5
4. Press the OK key to validate the hour value.
5. Press the "+" and "-" keys to set the correct
6. To finish, press the OK key again.
1
1
5 sec.
2. If you want to see the clock display again,
2,4,6
The minute numbers will start to flash.
minute value.
press the "+" and "-" keys again for 5
seconds.
EN
8