Introduction; Recommended Tools And Materials; Product Inspection; Contents - ProBoat SHOCKWAVE PRB0650 Manuel De L'utilisateur

Introduction

Once you hit the water, it's full speed ahead. The ready-to-run Pro Boat
on the lake and easy on the eyes. It's the one boat that's both no-nonsense and incredibly fun at the same time.
Whether you're new to RC boating or an experienced pro, the Shockwave 26 will keep you coming back for more.
Refer to this manual for instructions about assembly required to prepare your boat for operation.
Register your boat online at www.proboatmodels.com.

Recommended Tools and Materials

• Needle nose pliers
• Paper towel
• Rubbing alcohol
• Open-end wrench: 10mm (2)
• Nut driver: 7mm
• Phillips screwdriver: #1
• Hex wrench: 2.5mm, 3mm
• Clear tape (PRB0102)
• Pro Boat ® Marine Grease and Gun (PRB0100)
• Li-Po battery (DYNP4000EC)
or Ni-MH Battery (DYN1080EC)
• Li-Po battery charger (DYN4066)
or Prophet ™ Sport AC/DC Peak
Ni-MH Charger (DYN4056)

Specifications

26 in (660mm)
length
4.375 in (111mm)
Beam
Spektrum 2.4GHz
Transmitter
Pistol Grip Transmitter
(DX2E)

Battery Chemistry Switch

This switch allows the ESC to detect voltage. When the
switch is in the OFF position, low voltage cutoff (LVC)
is disabled. You will know you have reached LVC when
the motor power decreases while the boat is in operation.
li-po: move battery chemistry
switch to ON position
Ni-MH: move battery chemistry
switch to OFF position.
Tip: The ESC programming card
(DYNM3821, sold separately) allows the consumer to
adjust low voltage cutoff and other ESC programming.

Battery Safety precautions

• When using a Li-Po battery, always ensure the
Battery Chemistry Switch is in the ON position.
• Never discharge a Li-Po battery below 3V per cell.
Shockwave 26

product Inspection

Carefully remove the boat and radio transmitter from
the box. Inspect the boat for damage. If you find
damage is present, please contact the hobby
shop where you purchased your boat.

Contents

Spektrum ™
Receiver
Hull Material ABS Plastic
1500Kv
Motor
45 Amp brushless
ESC
At the factory, the ESC is programmed at High Cutoff.
High Cutoff: The Ni-MH cutoff voltage is .9 volts per
cell and the Li-Po cutoff is 3.3 volts per cell. High Cutoff
allows ample power in reserve after cutoff for returning
the boat to shore.
low Cutoff: The Ni-MH cutoff voltage is .7 volts per
cell and the Li-Po cutoff is 3.0 volts per cell. Low Cutoff
allows longer run times, but leaves less power in reserve
after cutoff for returning the boat to shore.
• Always disconnect a battery from the ESC
when not in use.
• Avoid continually operating to LVC, as
this could result in damage to the battery.
® ShockWave ® 26 Deep-V boat is agile
MR200 4 AA batteries (sold separately) are
required to operate the transmitter.
EN
3