Exit The System Setup Screen; System Setup Screen-2; Setting The Av Output Mode; Touch Sensor Tone - Kenwood LZ-7500 Mode D'emploi

Operation

System Setup Screen-2

A V - O U T
N O R M
V D 1
B E E P
O N
S Y S T E M

Touch Panel Adjustment Screen

T O U C H P A N E L
P l e a s e
t h e C e n
t h e B u t
L e f t - B o t t o m
C A N C E L
6 - English
N A V
V D 2
O F F
RTN
A D J U S T
T o u c h
t e r o f
t o n i n t h e
C o r n e r
R E S E T
Setting the AV Output Mode <AV OUT>
Touch Setting
[7NORMAL] Picture/sound with monitor picture
[7NAV] Navigation Sound
[7VD1] Picture/sound from <AV IN-1> terminal
[7VD2] Picture/sound from <AV IN-2> terminal
Touch Sensor Tone <BEEP>
Setting the operation check sound (beep sound)
ON/OFF.
Touch Setting
[7ON] Touch sensor tone is turned on
[7OFF] Touch sensor tone is turned off

Return to the System Setup Screen -1

Touch the [ 2 ] button.

Exit the System Setup Screen

Touch the [RTN] button.
Return to the setup menu screen.

Touch Panel Adjustment

The touch panel can be adjusted if the position
touched and the operation performed do not match.
1
Accurately touch the mark at the lower left.
2
Accurately touch the mark at the upper right.
When the mark at the upper right is touched, the
adjustment is completed and the system setup menu
screen reappears.
• If the [ CANCEL ] button is touched without touching the
button at the lower left, the adjustment is cancelled and the
screen that was set before switching to the system setup
menu reappears.
• If the [ CANCEL ] button is touched after touching the button
at the lower left, the button at the lower left reappears.
• If the [ RESET ] button is touched, the settings are reset to
the factory defaults and the setup menu screen reappears.