Troubleshooting - Zipper Maschinen ZI-BAS205 Mode D'emploi

TROUBLESHOOTING

20 TROUBLESHOOTING
Danger due to electrical voltage! Handling the machine with the power supply
up can lead to serious injuries or even death. Always disconnect the machine from
the power supply before servicing or maintenance work and secure it against
unintentional or unauthorised reconnection!
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains.
If you are unable to carry out necessary repairs properly and/or do not have the required
training, always consult a specialist to solve the problem.
Trouble
Motor does not work
The motor starts up
slowly and does not
reach operating speed
Motor makes excessive
noise
Motor does not reach its
full power
Motor overheats easily
Saw cut is rough or
wavy
Workpiece pulls away
and/or splinters
Saw blade is not
running straight
Burn marks appear on
the wood during the
cutting work
Saw blade jams during
cutting work
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BAS205 / ZI-BAS25053
WARNING
Possible cause
1. Front doors open (limit switch)
2. Motor, cable or plug defective
3. Fuses burned
1. Voltage too low
2. Coils damaged
3. Capacitor burned
Motor defect
Circuits in the network are
overloaded (other motors, etc.)
1. Overloading of the motor
2. Insufficient cooling of the
motor
1. Saw blade is dull
2. Tooth shape is not appropriate
for the material thickness
Excessive cutting pressure and/or
the saw blade is not suitable for
use
1. Saw band guide has been
wrongly set
2.
Wrong saw band
1. Blunt saw blade
2. Wrong saw blade
1. Blunt saw blade
2. Deposits on the saw blade
3.
Saw band guide has been set
poorly
Solution
1. Close front doors exactly
2. Contact an electrician
3. Contact an electrician
1. Contact an electrician
2. Contact an electrician
3. Replacement of the capacitor by
a qualified electrician
Replacement of the motor by a
qualified electrician
Do not use any other equipment or
motors on the same circuit
1. Avoid overloading the motor
while cutting.
2. Remove dust from the motor in
order to ensure optimal cooling
of the motor
1. Resharpen the saw blade
2. Use a suitable saw blade
Insert a suitable saw blade
1. Set the saw blade guide
according to the operating
instructions
2.
Select a saw blade according to
the operating instructions
1. Change the saw blade
2. Select a saw blade according to
the operating instructions
1. Change the saw blade
2. Clean the saw blade
3. Set the saw blade guide
according to the operating
instructions
53