Secure The Bandsaw To The Floor; Assembly - Zipper Maschinen ZI-BAS205 Mode D'emploi

ASSEMBLY

An adequate distance must be provided for the feeding of long workpieces in front of and behind
the machine.

Secure the bandsaw to the floor

Assembly
The machine is delivered almost ready for operation. Prior to operation, the machine must only
be secured against tipping over and the following components must be attached or mounted:
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BAS205 / ZI-BAS25039
Secure the wood band saw to the floor at the place of
installation using screws to prevent the machine from tipping
over during operation. The machine base has a total of four
through holes (B) for this purpose - see illustration on the
left.
1. Assembly of the worktable
 Dismantle the two screws M6x20 (S), the two
nuts (N) and the clamp (C) from the worktable.
 Lift the work table (WT) to the mounting position
on the bench angle gauge
blade into the work table (WT).
 Position the table inlay (TI) on the work table
properly.
Check that the table inlay is at the
same height as the machine table.
 Fasten the worktable to the bench angle gauge
(B) using three screws (M6x16), three washers
and three nuts (M6).
(B). Thread the saw
NOTICE
39