Adjusting Lower Saw Band Guide - Zipper Maschinen ZI-BAS205 Mode D'emploi

ADJUSTMENTS
Lateral guide discs

16.5.2 Adjusting lower saw band guide

The upper saw band guide consists of the following components:
 Rear thrust bearing
 Lateral guide discs
Rear thrust bearing
Lateral guide discs
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BAS205 / ZI-BAS25045
The lateral guide pins should slightly strip the saw
band to obtain a vibration-free and straight cut.
Procedure:
 To adjust, loosen the clamping nuts (CN) and
press the lateral guide discs (GD) up to 0.5 mm
to the saw band.
 Then retighten the clamping nuts (CN).
Procedure:
 Loosen the two screws (M6x20) and nuts (N).
Remove the u-shaped clamp (C) from the
worktable.
 To disassemble the worktable from the bench
angle gauge (AG), loosen the three screws
(M6x16), washers and nuts (N).
 Raise the upper blade guide fully (see 16.6).
 Loosen the two locking screws (LS) and
remove the bench angle gauge (AG).
 Open the lower front door (F).
 To adjust, loosen the clamping screw (CS) and
position the rear thrust bearing (TB) at a
distance of about 0.5 mm from the saw band
back.
 Then tighten the clamping screw (SC) again.
Procedure:
 To adjust, loosen the clamping nuts (CN) and
press the lateral guide discs (GD) up to 0.5 mm
to the saw band.
 Then retighten the clamping nuts (CN).
45