Power Supply - Zipper Maschinen ZI-BAS205 Mode D'emploi

ASSEMBLY

Power Supply

Dangerous electrical voltage! Connection of the machine as well as electrical
inspections, maintenance and repair may only be carried out by qualified
personnel or under the supervision and supervision of a qualified electrician!
When working with non-grounded machines: Severe injury or even death may
arise though electrocution!
Therefore: The machine must be operated at a grounded power socket.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BAS205 / ZI-BAS25040
2. Assembly of the clamp
 Mount the clamp (C) using two screws (M6x20)
and two nuts (N).
3. Assembly of the push stick
 Fix the screw (M6x35) with the nut (M6) onto the
machine.
 Only tighten the screw with the nut on the
machine to a point where a secure hold is
guaranteed and the push stick (PS) can be hung
on it.
4. Assembly of the rip fence
 Position the rip fence (RF) on the worktable.
 The rip fence is fixed by turning the locking lever
(LL) downwards.
 To release the fixation, the locking device has to
be turned upwards.
 The rip fence can be applied to both sides of the
saw blade.
5. Machine assembly completed
WARNING
WARNING
40