Getting Started; Base Assembly - Vornado NGT335 Mode D'emploi

GETTING STARTED

BASE ASSEMBLY

1. Place tower circulator horizontally on a table with soft cloth
underneath to avoid scratches. Allow base to extend over edge
of table.
8 English
2. Insert one leg into any of four recesses underneath the tower. Push
leg until it locks into place.
Note: To avoid damage, DO NOT FORCE legs into recessed areas —
they should easily click into place.
3. Next to previously installed leg, partially insert another leg into a
recess on the base. Just before locking into place, connect both
legs. Repeat for remaining legs.
Note: You may need to flex the legs to get the last of the legs
to interlock.
4. Base assembly is complete. Position tower circulator upright to
begin use.
English
9