Mount The Rf5132-433 And Wireless Devices - DSC PowerSeries RF5132-433 Manuel D'installation

Read the test results at the keypad::
Result LED Keypad
Good Light 1 On Steady
Bad Light 3 On Steady
Activate the device until you get 3 'good' results in a row.
You may mount the WLS devices where results were good.
Devices indicating a bad result must be moved to another location. You may only have to move the device a
few inches to correct a bad result.
Do not mount any device where a "bad" test result was indicated.
7. Go to the next device to be tested and activate it until the test result is displayed/sounded.
NOTE: Wait until the placement test of one device is shown/sounded before beginning to test the next
device.
Continue to test the devices until both the RF5132-433 and the devices are in good locations. If several
wireless devices produce 'bad' test results, you may need to move the RF5132-433 to a better location.
(See section 2.2 for tips on finding a location for the RF5132-433.)
8. To exit the placement test and return to installer programming, press [#] twice.
Testing Individual Devices:
1. Temporarily place the device where you want to mount it.
2. At a system keypad, enter [*][8][Installer Code].
3. Enter programming section [904].
4. Ensure option 8 in section [90] is disabled.
5. Enter the 2-digit zone number for the device to be tested.
6. Activate the device being tested until a result is displayed on the keypad or sounded by the keypad or bell.
(Same as step 5 in the Global Placement Test section, previous page.)
7. To test another device, press [#] once, then repeat steps 4 - 5. Continue to test the devices until both the
RF5132-433 and the devices are in good locations.
If several wireless devices produce 'bad' test results, you may need to move the RF5132-433 to a better
location. (See section 2.2 for tips on finding a location for the RF5132-433.)
8. To exit the placement test and installer programming, press [#] twice.
Testing Individual Wireless Keys:
Do not use the individual device test described above to test the wireless keys. To ensure that the RF5132-433
receiver is receiving transmissions from these devices, use the function keys on these devices at several different
points in the installation.

5.2 Mount the RF5132-433 and Wireless Devices

When you have tested reception of the RF5132-433 with all the wireless devices (see section 5.1) and you have a
good mounting location, mount the RF5132-433:
1. Pull the Keybus wires through the hole at the bottom of the cabinet.
2. Mount the cabinet securely to the wall.
LCD Keypad Buzzer/Bell
"Good" 1 Beep/Squawk
"Bad" 3 Beeps/Squawks
13