Enroll & Program Wireless Keys - DSC PowerSeries RF5132-433 Manuel D'installation

3. Enter the 2-digit number corresponding to the zone the device is to occupy ([01] to [32]).
NOTE: Hardwired and wireless devices cannot be assigned to the same zone. PC5108 zone expander modules
occupy zones in 2 groups of 4 (e.g. zones 9-12 and zones 13-16). None of the zones assigned to a PC5108
module may be used for wireless devices. For more information on zone assignment, consult your system
Installation Manual.
4. Enter the device ESN. The entry must be 6 digits.
5. The device is now enrolled on the system. Record the serial number and the assigned zone number in the
programming worksheets in the back of this manual.
6. Continue with steps 3 - 5 until you have enrolled all wireless devices.
7. To exit press [#].
NOTE: The devices will not work properly until you complete zone and partition programming (see section 4).
3.4 Enroll & Program Wireless Keys
For wireless keys to work on the system, you need to enroll them and then program the function buttons, if the default
values are not the functions desired. Wireless keys are not assigned to zones and require no zone programming. You
can enroll up to 16 wireless keys on the system.
Enroll Wireless Keys
1. Enter [*][8][Installer's Code] to go to the installer's programming section.
2. Enter programming section [804].
3. Enter a 2-digit number [41]-[56] to program the wireless key serial number. These numbers correspond to wireless
key numbers 01- 16.
4. Enter the device ESN. The entry must be six digits.
5. The key is now enrolled on the system. Record the serial number and the assigned slot number in the programming
worksheets in the back of this manual.
6. Repeat steps 3 - 5 until all wireless keys have been enrolled.
7. (PC5020/PC1616/PC1832/PC1864/PC501X only) By default, all wireless keys are assigned to Partition
1. To assign keys to different partition, see programming section [69].
NOTE: A wireless key can only be assigned to one partition.
8. To exit press [#].
Programming the Wireless Keys Function Buttons
Wireless keys have four programmable function buttons. Default functions have been assigned, but you may program
other functions if desired. After the functions are programmed, when you press and hold one of the four buttons for one
second, the system will execute the programmed function.
For systems using partitions (PC5020/PC1616/PC1832/PC1864/PC501X only): All wireless keys
assigned to Partition 1 will have the four functions programmed in section [61]. All wireless keys assigned to Partition
2-8 will have the four functions programmed in section [62-68]. For example, if function button 1 in Section [61] is
programmed for Stay arming, then pressing the first button on any wireless key assigned to Partition 1 will Stay arm
Partition 1.
NOTE: Wireless keys will not work when the partition they are assigned to is being accessed for zone bypassing or
programming.
1. At a system keypad, enter [*][8][Installer's Code].
2. Enter programming section [804].
7